Designed to exhaust excessive heat from polythene clad greenhouses. Usually used with a climate controller.
Simply cut out a 30-35cm hole in your polytunnel cover, insert the fan from the inside in a rotating motion, and clip on to the support bars.
Support bar kits are optional extras, please select the size hoop for the size of your tunnel
Air flow: 4,600m³/hr (2,700cfm)
Requires single phase 220-240v power supply
200w (0.9A) motor
IP55 protected
Weight: 7.5kg
Top diameter at cowl: 42cm
Overall diameter at base: 57cm
Overall height: 39cm
Comes with a mesh guard on the inlet
Designed to exhaust excessive heat from polythene clad greenhouses. Usually used with a climate controller.
Simply cut out a 30-35cm hole in your polytunnel cover, insert the fan from the inside in a rotating motion, and clip on to the support bars.
Support bar kits are optional extras, please select the size hoop for the size of your tunnel
Air flow: 4,600m³/hr (2,700cfm)
Requires single phase 220-240v power supply
200w (0.9A) motor
IP55 protected
Weight: 7.5kg
Top diameter at cowl: 42cm
Overall diameter at base: 57cm
Overall height: 39cm
Comes with a mesh guard on the inlet